Place the top platform with the bottom facing upwards.
Align the right leg with the holes on the top platform.
Secure the leg to the top platform with two washers and two screws. Using the hex wrench, tighten until resistance is felt.
Repeat steps 2 and 3 for the left leg.
Place the middle platform with the bottom facing up. Position the middle platform with the top platform and legs so that the holes align.
Secure the right leg to the middle platform with two washers and two screws. Using the hex wrench, tighten until resistance is felt.
Secure the left leg to the middle platform with two washers and two screws. Using the hex wrench, tighten until resistance is felt.
Align the leg brace with the legs.
Secure the leg brace to the legs using two screws, two washers and two cap nuts for each leg. Using the wrench and hex wrench, tighten until resistance is felt.
Place the bottom platform upside down and align the bottom platform with the middle platform.
Place the straight support braces onto the middle and bottom platforms. Line up the holes on the braces with the holes on the platforms.
Secure the straight support braces using fours screws and four washers for each brace. Using the hex wrench, tighten until resistance is felt.
Place the ramp in the upright position.
